FPA‑1000 Analog Addressable Fire Panels

FPA‑1000 Analog Addressable Fire Panels
  • Support for up to 508 points on two analog addressable loops
  • Built-in Ethernet connector for web-browser based programming and Conettix Alarm-over-IP communication
  • Two on-board NACs and dual-line PSTN DACT
  • Peer-to-peer networking of up to eight -V2 panels in a single group
  • Suited to a wide range of applications and compatible with the latest Bosch solutions - including 440 Series Multi-criteria detectors
  • Simple system management and free online training
  • Variety of communication channels
  • Gas detection
  • Overview
    Mains power supply (primary)
    Supervision Supervised for the presence of AC power
    Voltage 120 VAC, 60 Hz, 1.1 A maximum, or240 VAC, 50 Hz, 0.6 A maximum
    Power supply (secondary) with battery backup
    Voltage 24 VDC
    Supervision Supervised for the presence of AC power
    Current consumption (standby) 1.25 A maximum
    Current consumption (alarm) 5 A maximum 1.0 A maximum shared between panel and SLC(s) Panel ≤ 250 mA SLC 1 = 60 mA/card + 220 mA/loop maximum SLC 2 = 60 mA/card + 220 mA/loop maximum 4.0 A maximum shared between NACs, Option Bus, and AUX power NACs (non-synchronized) NAC 1 =2.5 A maximum NAC 2 = 2.5 A maximum NACs (synchronized) NAC 1 + NAC 2 in total = 2.75 A maximum Option Bus = 0.5 A maximum AUX/FWR = 0.5 A maximum AUX/RST = = 0.5 A maximum
    Battery capacity 7.0 Ah minimum, 40 Ah maximum
    Charge current 2.0 A maximum
    Fuse 15 A blade-type
    Suitable battery type Two 12 VDC in series (7 Ah or 18 Ah in enclosure, 24 Ah or 38 Ah in additional battery box) Recommended Manufacturers: POWER SONIC: PS-1270, PS-12170, PS‑12180 YUASA: NP7-12, NPG18-12
    Maintenance Replace batteries when they fail the Battery Load test
    Auxiliary power supply
    AUX/FWR Full Wave Rectified 500 mA at 24 V FWR (17 to 31 VRMS), non‑switched, power-limited, unfiltered, non‑supervised
    AUX/RST Resettable 500 mA at 24 V FWR (17 to 31 VDC), switched, power-limited, filtered, non‑supervised
    Line impedance for ground fault detection (Option Bus, SLC, NAC, secondary power circuit, City Tie/Local Energy, AUX) 15 kΩ
    Option Bus (OB)
    Voltage Nominal 12 VDC, power-limited, supervised
    Current 500 mA maximum
    Configuration 1 Class B
    Circuit wiring distance 4000 ft. (1219 m) maximum, depending on wire gage and connected devices
    Notification appliance circuits (NACs)
    Mainboard NACs Two (NAC 1 and NAC 2)
    NAC power from panel Nominal 24 V FWR (17 to 31 VRMS), regulated, power-limited, supervised2.5 A per NAC, maximum current limited to overall 4.0 A shared among AUX power, Option BUS, and NACs
    Line impedance 1.45 Ω maximum
    Configuration Two Class B or two Class A
    Signaling line circuits (SLCs)
    Voltage Nominal 39 VDC (29 VDC to 40 VDC), power‑limited, supervised
    Current 204 mA (per FPE-1000-SLC)
    Circuit resistance <50 Ω
    Circuit capacitance <1 ΩF
    Circuit inductance <1 mH
    Configuration 1 or 2 Class B or 1 Class A or 1 Class X
    City Tie
    Circuit resistance 65 Ω maximum
    Wire gauge 12 AWG to 18 AWG (ISO 4 mm2 to 0.75 mm2)
    City Tie - Local Energy Mode
    Type of connection In series
    Alarm, trip coil 24 VDC
    Alarm current 250 mA DC (momentary)
    Supervisory/standby current <50 mA DC
    Trip coil resistance 14.5 Ω
    Nominal coil voltage 3.65 VDC, power-limited, supervised
    City Tie - Reverse Polarity Module
    Nominal voltage Nominal 24 VDC (26.4 VDC maximum), power‑limited, supervised
    Output current 33 mA maximum
    Supervisory/standby current 5 mA
    Networking cards
    Current (per card) FPE-1000-NE: 100 mA FPE-1000-NF: 170 mAFPE-1000-NW: 330 mA
    Circuit wiring distance (actual length depends on connector quality) FPE-1000-NE: 328 ft. (100 m)FPE-1000-NF: 6560 ft. (2000 m) or 10 db lossFPE-1000-NW: 3280 ft. (1000 m) maximum

    Images

     
  • Certificates (3)
    Title Type Language
    UL PDF
    CSFM PDF
    FDNY-CoA PDF
     
  • Documents (16)
     
  • Software & Support (3)
     
 

Product variants

FPA-1000-LT 類比/網路可定址控制主機,無變壓器

FPA‑1000‑V2 fire panel without transformer. For Latin America only.

Commercial Type No.: FPA-1000-LT
Product No.: F.01U.082.721

 

Accessories

D5070 手持式類比裝置點編程器

D5070 手持式類比裝置點編程器

Used to program address settings on EEPROM‑programmable analog devices

Commercial Type No.: D5070
Product No.: 4.998.800.577

 
D7030X 8 警示 LED 通報裝置

D7030X 8 警示 LED 通報裝置

Eight zone LEDs indicate alarm conditions.

Commercial Type No.: D7030X
Product No.: 4.998.800.536

 
 
D7030X-S2 8 LED 通報裝置 (2 監控)

D7030X-S2 8 LED 通報裝置 (2 監控)

Two LEDs indicate supervisory conditions, six indicate alarm conditions.

Commercial Type No.: D7030X-S2
Product No.: 4.998.140.386

 
D7030X-S8 8 LED 通報裝置 (8 監控)

D7030X-S8 8 LED 通報裝置 (8 監控)

All eight zone LEDs (yellow) indicate supervisory conditions.

Commercial Type No.: D7030X-S8
Product No.: 4.998.140.387

 
 
D7032 8 LED 通報裝置擴展器

D7032 8 LED 通報裝置擴展器

Use with D7030X Family LED annunciators

Commercial Type No.: D7032
Product No.: 4.998.140.388

 
D7035 8 路繼電器多工模組

D7035 8 路繼電器多工模組

Provide eight Form C relay outputs (w/o enclosure) for the D7024, FPD-7024, or FPA‑1000 Fire Alarm Control Panels (FACP)

Commercial Type No.: D7035
Product No.: 4.998.800.539

 
 
FAA-325-B4 類比感應器底座 4 吋

FAA-325-B4 類比感應器底座 4 吋

Is combined with analog addressable detectors that use the advanced digital communication protocol to provide early fire warning for life safety and property protection

Commercial Type No.: FAA-325-B4
Product No.: F.01U.133.061

 
FAA-325-B6S 類比感應器底座 6 吋,附聲音警報器

FAA-325-B6S 類比感應器底座 6 吋,附聲音警報器

Contains an addressable sounder which provides an audible alarm in the immediate vicinity and only works in combination with one of the FAH‑325, FAI-325, or FAP‑325 analog sensors

Commercial Type No.: FAA-325-B6S
Product No.: F.01U.133.063

 
 
FAA-440-B6 類比裝置標準型底座 6 吋

FAA-440-B6 類比裝置標準型底座 6 吋

Standard 6-inch base. Used in combination with FAP-440 and FAH-440 detectors to provide early fire warning for life safety and property protection.

Commercial Type No.: FAA-440-B6
Product No.: F.01U.164.308

 
FCC-380 CO 濃度偵測器 (Macurco CM-E1)

FCC-380 CO 濃度偵測器 (Macurco CM-E1)

Carbon monoxide detector

Commercial Type No.: FCC-380
Product No.: F.01U.172.606

 
 
FLM-325-2I4 FPA-1000 用雙路輸入模組

FLM-325-2I4 FPA-1000 用雙路輸入模組

Provides two independent contact monitoring circuits to monitor Normally Open (NO) or Normally Closed (NC) dry contact types of fire alarm devices

Commercial Type No.: FLM-325-2I4
Product No.: F.01U.133.068

 
FLM-325-CZM4 FPA-1000 用常規分區模組

FLM-325-CZM4 FPA-1000 用常規分區模組

Enables the FACP to interface and monitor up to 25 conventional devices depending on the device type such as two‑wire smoke detectors or pull stations

Commercial Type No.: FLM-325-CZM4
Product No.: F.01U.133.067

 
 
FLM-325-ISO FPA-1000 用短路隔離器

FLM-325-ISO FPA-1000 用短路隔離器

Isolates a shorted section on a specific polling circuit from the rest of the system to minimize the loss of communication

Commercial Type No.: FLM-325-ISO
Product No.: F.01U.133.071

 
FMM-325A 類比單作用人工操作站,紅色

FMM-325A 類比單作用人工操作站,紅色

The single‑action manual station is UL listed for commercial fire applications and meets Americans with Disabilities Act (ADA) requirements. Set the address on the polling circuit by programming an EEPROM microchip with the D5070 Analog point programmer.

Commercial Type No.: FMM-325A
Product No.: F.01U.246.085

 
 
FMM-325A-D 類比雙作用人工操作站,紅色

FMM-325A-D 類比雙作用人工操作站,紅色

The double‑action manual station is UL listed for commercial fire applications and meets Americans with Disabilities Act (ADA) requirements. Set the address on the polling circuit by programming an EEPROM microchip with the D5070 Analog point programmer.

Commercial Type No.: FMM-325A-D
Product No.: F.01U.246.087

 
FMR-1000-RA LCD 通報裝置 FPA-1000 無控制器

FMR-1000-RA LCD 通報裝置 FPA-1000 無控制器

LCD annunciator without system control capability for use with the FPA‑1000 Analog Addressable Fire Panels

Commercial Type No.: FMR-1000-RA
Product No.: F.01U.066.880

 
 
FMR-1000-RCMD LCD 通報裝置 FPA-1000 附控制器

FMR-1000-RCMD LCD 通報裝置 FPA-1000 附控制器

LCD annunciator with system control capability for use with FPA‑1000 Analog Addressable fire Panels

Commercial Type No.: FMR-1000-RCMD
Product No.: F.01U.066.879

 
FPE-1000-SLC FPA-1000 用 SLC 插件模組

FPE-1000-SLC FPA-1000 用 SLC 插件模組

Provides a Signaling Line Circuit (SLC) for connection of analog devices to the FPA‑1000 Analog Addressable Fire Panels

Commercial Type No.: FPE-1000-SLC
Product No.: F.01U.073.062

 
 
FPP-RNAC-8A-4C RNAC 電源供應器 8A 24V

FPP-RNAC-8A-4C RNAC 電源供應器 8A 24V

When connected to a panel’s option bus, the FPP-RNAC-8A-4C adds four additional NFPA 72, Class B or Class A NACs. When connected directly to the NAC output, it is also a NAC power supply for fire-protective signaling systems.

Commercial Type No.: FPP-RNAC-8A-4C
Product No.: F.01U.003.444