| |
Model No.1) | Rated Motor Voltage , Operational Voltage Range |
LTC9418/60 | 110 VAC, 60 Hz , 108 to 132 VAC |
LTC9418/20 | 24 VAC, 60 Hz , 21.6 to 26.4 VAC |
LTC9418/10 | 24 VAC, 50 Hz , 21.6 to 26.4 VAC |
LTC9418/50 | 220 VAC, 50 Hz , 207 to 253 VAC |
Connectors | |
Power | Via 24-pin connector on base |
Ground | Screw connection for grounding on base |
Recommended Maximum Cable Lengths: | |
Model | Wire Size , Distance |
Voltage2) | mm2) , AWG , Feet , Meters |
24 VAC | 0.5 , 20 , 140 , 43 |
1 | 18 , 230 , 70 |
1.5 | 16 , 360 , 110 |
2.5 | 14 , 590 , 180 |
4 | 12 , 940 , 287 |
115 VAC | 0.5 , 20 , 2200 , 671 |
1 | 18 , 3500 , 1067 |
1.5 | 16 , 5500 , 1677 |
2.5 | 14 , 9000 , 2744 |
230 VAC | 0.5 , 20 , 13400 , 4085 |
1 | 18 , 21200 , 6463 |
1.5 | 16 , 33300 , 10152 |
2.5 | 14 , 54400 , 16585 |
| |
Mounting | These units are designed for either upright or inverted installations. To maintain weatherproof integrity when mounting outdoors in an inverted position, the unit must be installed in a weatherproof enclosure (e.g., weatherproof domed housing), or a protected outside area. They can only be mounted upright or inverted; never horizontally. |
Pan Range (Movement in horizontal plane) | 0° to 345° maximum |
Pan Speed | 7°/seconds |
Tilt (Movement in vertical plane) | +30° to –90° from horizontal |
Tilt Speed | 3.5°/s seconds |
Maximum Load | 149 kg-cm (129 lb-in.) torque or 10 kg (22 lb) at a distance of 63.5 mm (2.5 in.) from the center of mass of the camera/lens/housing assembly to the center of the tilt table |
Construction | Cast aluminum base and yoke, corrosion resistant plastic cover |
Finish | Light gray |
Dimensions | See Dimensional Outline |
Weight | 6.21 kg (13.7 lb) |
| |
Temperature | Operating: –30°C to +60°C (–22°F to +140°F) |
Storage: –40° to +60°C (–40°F to +140°F) | |
Vibration | 3 g swept sine wave, 15 Hz to 2000 Hz |
Shock | 50 g, 11 ms, 1/2 sine |
Enclosure | Tested to IP54 requirements (upright mount- ing). UL 50 Type 3/NEMA-3 design. |